First, the end face has burrs and is not smooth
Aluminum cutting machine burr phenomenon, it is necessary to check whether the number of teeth of the matched saw blade is too dense, and the accuracy of the main shaft of the aluminum cutting machine equipment, foreign bodies in the flange, and the straightness of the saw blade walking. There is also a need for everyone to pay attention to whether the lubrication of the supporting lubrication equipment is in place.
Second, the end face is not smooth, saw marks
The surface of the product after processing by the aluminum cutting machine has saw marks. If the equipment spindle accuracy is relatively poor, it is equipped with a good saw blade, the bias is relatively large will lead to sawing lines, and the finish can be imagined. Secondly, the effect of lubrication on the finish is also very large.
Third , sawing accuracy is not accurate
The size of the material processed by the aluminum cutting machine is large and small, which will directly lead to the appearance of defective products, and the bulk down will cause immeasurable losses to the enterprise. Therefore, when similar problems occur, it is necessary to check whether there is a problem with the backing and verticality of the equipment, as well as the feeding device.
