Why Back Off the Tension for Long Stops
If you're shutting down the saw for more than a full day-say, over a weekend or a holiday-don't just walk away and leave the blade under full tension. That constant pull will slowly stretch the metal and lead to fatigue cracks over time. A good habit is to back off the tension until the blade feels noticeably looser, roughly down to 30–50% of its normal working tension. You don't need to measure it precisely with a gauge; just enough so the blade has some slack but isn't flopping around. This small step can add a lot of life to your blades.
How to Store Blades Without Damaging Them
Now, about storing blades that aren't on the machine. Never just toss them on the floor or lean them against a wall. Blades are surprisingly easy to twist or kink, and once they get a set in them, they'll never run true again. The best way is to hang them on a smooth, clean peg, or lay them flat on dry wooden racks. Wood is good because it won't react with the steel or trap moisture like metal or concrete can. If you have to stack blades, put a piece of cardboard or wood between each one.
Rust Protection and Where to Keep Blades
Before putting a blade away for a while, wipe a thin coat of regular rust-preventive oil over the surface. You don't need expensive specialty sprays-basic machine oil works fine. Pay extra attention to the tooth area and near the weld joint, where rust likes to start. Keep the stored blades away from battery charging areas, chemical drums, or anyplace that gets hot or damp. A dry, room-temperature corner of the tool room is perfect. Treat your blades decently, and they'll cut straight and last longer.





